Table of Contents
Advertisement
73355 rev3
29/11/07
Ê
È
F F o o r r A A d d v v i i c c e e , , S S p p a a r r e e s s o o r r A A c c c c e e s s s s o o r r i i e e s s , , t t e e l l : :
4
11:56
Page 4
OPERATING THE
A
APPLIANCE
Assembly
WARNING: Do not plug in
the cleaner until it is
assembled.
1
Carefully unpack all of the
components.
2
Lift the cleaner body to the
upright position.
Remove the two upper screws
3
that are either side of the cable
storage and remove the dust
B
canister.
4
Insert the handle into the main
body of the cleaner and push
down firmly before re-fitting and
tightening the screws A.
5
Re-attach the dust canister.
IMPORTANT: The cleaner may
not operate correctly if the
canister is not securely in
position, so please ensure that
the handle is correctly fitted
before attaching the canister.
Using on carpets
1
Place the cleaner in it's upright
position.
2
Release the mains cable by
turning the quick release cleat
 half-a-turn and extend the
cable fully.
C
3
Plug the cable into the mains
socket.
4
Step on the upright release
pedal · to release the handle
to the desired position.
5
Press the control switch on the
handle to setting 'II' (carpet).
•
Note: The beater bar will
automatically switch off when
the cleaner is parked upright.
IMPORTANT: To prevent damage
to carpets, never leave the
cleaner switched on in one
place for an extended period.
Using on hard floors
Follow steps 1-4 from the
instructions for 'Using on
carpets'
5
Press the control switch on the
handle to 'I' (hardfloor)
NOTE: The beater bar does not
rotate with the power switch set
to 'I' (hardfloor)
Eco Switch
Slide the Eco Switch ‹
upwards to increase the suction
power or downward to decrease
suction B. This feature is most
useful when using the hose and
accessories. Use the minimum
setting when vacuuming
delicate fabrics/curtains etc.
When not using the hose, it is
advisable to keep the variable
slider set to maximum.
Using the hose and
attachments
1
Take the hose connector out of
the storage clip.
2
Pull down the hose connector
flap È and insert the hose
connector with it's 'mouth'
pointing upwards C.
IMPORTANT: Push the hose
connector fully in such that the
flap È latches on to the hose
connector Ê.
Add the required accessory to
3
the extension tubes or directly
to the tube connector Ë when
using the hose and tools.
IMPORTANT: Turning the cleaner
sideways helps prevent the
cleaner being pulled along by
the stretch hose.
IMPORTANT: Remove the hose
connector before returning to
floor cleaning with the main
nozzle. Push the flap down to
disengage the latch before
pulling out the connector.
0 0 8 8 4 4 5 5 0 0 7 7 7 7 7 7 7 7 0 0 0 0 ( ( U U K K ) )
o o r r
1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9 ( ( I I r r e e l l a a n n d d ) )
Advertisement
Table of Contents
