• Only use this vacuum cleaner as described in this user guide and only use attachments recommended by Kogan.com. • Do not use if the cord or plug is damaged. If the vacuum cleaner is not working properly, has been dropped, damaged, left outdoors, or submerged in water, take it to a service centre.
Page 4
• This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Page 7
ASSEMBLY Insert the hose connection into the vacuum cleaner by rotating it until you hear a click. To remove the hose, press the release button on the side of the hose connection and pull it out. Attach the extension tube to the other end of the hose. Attach the floor brush to the extension tube.
OPERATION Powering the Vacuum Cleaner Before using the vacuum cleaner, first roll out a sufficient length of the power cord and plug it into the electrical outlet. The yellow mark on the power cable indicates the maximum length that should not be exceeded. To switch the vacuum cleaner on/off, press the ‘Power’...
Page 9
Accessories Floor nozzle: The floor nozzle is suitable for both carpets and hard floors. The foot switch allows you to switch between carpet and hard floor modes. A brush and a rubber lip extend from the underside of the nozzle for use on hard floors. Carpet mode Hard floor mode Crevice nozzle:...
Page 10
Emptying the Dust Container Empty the dust container when the collected dirt reaches the ‘MAX’ mark or when the suction power decreases. Switch off the vacuum cleaner and unplug it from the electrical outlet. Always pull on the plug, not the cord, when disconnecting. Release the dust container by pressing the ‘Release’...
CLEANING & CARE Cleaning the Vacuum Body • Wipe the vacuum cleaner with a damp cloth to clean it. • Do not use strong solvents or abrasive cleaning agents. Cleaning the Motor Filter Turn off and unplug the vacuum cleaner. Remove the dust container.
Page 12
Cleaning the Exhaust Air Filter The exhaust air filter cleans the air before it leaves the vacuum cleaner. Clean the exhaust air filter as follows: Turn off and unplug the vacuum cleaner. Always pull the plug, not the cord. Remove the dust container. Open the exhaust filter cover.
Page 16
Need more information? We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com...
Need help?
Do you have a question about the KAVACBA22WA and is the answer not in the manual?
Questions and answers