Magtek iDynamo 6 User Manual & Setup Manual page 3

Setup
How To Load Paper Roll
The MagTek iDynamo 6 does not have a built-in receipt printer.
Thermal receipt paper rolls cannot be installed in this device.
Power
The iDynamo 6 is not controlled by a simple on/off switch.
Instead, it connects to power when linked to a host via USB.
Merchants can tell if their iDynamo 6 is receiving power when the
LED status indicator has a green light.
Merchants will receive their device partially charged; MagTek
recommends charging at least two to three hours (via Lightning
and USB-C cable) before use.
Connecting to Android Type-C Host via USB
1. Ensure that your Android host device is receiving power.
2. Connect to iDynamo 6 using a USB-C cable.
3. Configure host app settings and ensure the connection is
stable. If necessary, install the host app.
4. Perform a test using the host or MagTek test app.
Disconnecting iDynamo 6 from Android Type-C Host via USB
1. Disconnect from all apps.
2. Close host display.
3. Carefully remove the USB-C cable from the iDynamo 6 USB
connector. Damaging the cable could cause connection issues.
MagTek iDynamo 6 - Default Password
The default password for the MagTek iDynamo 6, Dynamag, and
eDynamo is 000000.
PaymentCloud LLC. • 800-988-2215 • support@paymentcloudinc.com
MagTek iDynamo 6
User Manual & Setup Guide
Table of Contents
Overview
2
Setup 3
Accept Payments 4
Settings 6
Troubleshooting 7
& Tips
Rights Reserved 10
Additional Information
Spec Sheet
Shop MagTek
iDynamo 6
V.022025 3