Goodwe ET G2 Quick Start Manual

Residential Smart Inverter Solutions
ET G2 6-15kW+Lynx Home F / Lynx Home D
Quick Guide
The information in this quick guide is subject to change due to product updates or other reasons. This guide cannot re-
place the product labels or the safety precautions in the user manual unless otherwise specified. All descriptions in the
manual are for guidance only.
01 Networking
Device Model
GW6000-ET-20, GW8000-ET-20,
Inverter GW9900-ET-20, GW10K-ET-20, GW12K-
ET-20, GW15K-ET-20
Lynx Home F (G1)
Lynx Home F (G1 Plus+)
Battery LX F6.6-H Lynx Home D
system LX F9.8-H LX D5.0-10
LX F13.1-H
LX F16.4-H
WARNING
Description
A maximum of 4 inverters can be connected in a parallel system.
Inverter firmware requirements for parallel connections:
• Consistent firmware version
• ARM version: 01.389 or above
• DSP version: 01.15 or above
• A maximum of 8 battery systems can be clustered in a system.
• Do not mix connect battery systems of different versions.
Device Model
Smart
• GM3000
Meter (Op-
• GM330
V1.0-2024-06-17
tional)
• WiFi/LAN Kit-20
Smart • 4G Kit-EC or 4G Kit-AU
Dongle
• Ezlink3000
02 Power On/Off
Power on/off
1 2 3 4 5
1
Description
• The inverter has a built-in smart meter, and CT cannot be
changed.CT ratio: 90A/90mA
• GM3000: GM3000 and the CT, which cannot be replaced, are
included in the inverter package. CT ratio: 120A/40mA.
• CM330: order the CT for GM330 from GoodWe or other suppli-
ers. CT ratio: nA/5A.
• nA: CT primary input current, n ranges from 200 to 5000.
• 5A: CT Secondary input current.
• In single scenarios, please use WiFi/LAN Kit-20, 4G Kit-EC, or
4G Kit-AU modules.
• In parallel scenarios, the EzLink 3000 must be connected to
the master inverter. Do not connect any communication
module to the slave inverters. The firmware version of EzLink
should be 04 or above.
④ : Install or not based on
local laws and regulations.
6