Urmet 1750, 1750/2 Manual

Also See for 1750:

Quick start manual (18 pages)

Installation instructions manual (12 pages)

Manual (17 pages)

Table of Contents

Contents

1 DESCRIPTION OF COMPONENTS AND FEATURES
2 DESCRIPTION OF TERMINALS
3 INSTALLATION
4 BUTTON FUNCTIONS
- 4.1 INDICATOR LEDS
- 4.2 RESET
5 TECHNICAL SPECIFICATIONS
6 Documents / Resources
- 6.1 References
- 6.2 Download manual

Urmet 1750, 1750/2 Manual

DESCRIPTION OF COMPONENTS AND FEATURES

Door opener button
Green LED under door opening button
Button
Button
Button
Two-colour LED
Terminals for connecting to the system
Configuration dip switch:
1. 2 to define the station number in the apartment
2. 8 to define the apartment number in the column

information Refer to the system booklet for how to set the dip switches.

In-out connection setup with Ref. 1750/50
Brightness
Colour
Screws for fixing video door phone to bracket

DESCRIPTION OF TERMINALS

INSTALLATION

Fix the bracket to the wall using a box 503 and the screws provided or a Ø 60 box with suitable screws.
Program the dip switches.
Connect the wires from the system to the terminal board.
Couple the monitor to the bracket and lock it by screwing fastening screws A.

INSTALLATION DIAGRAM

BUTTON FUNCTIONS

	STATE
BUTTON	STANDING BY ON-HOOK	RINGING ON-HOOK (RECEIVING CALL)	DURING AUDIO OPERATION	STANDING BY OFF-HOOK	PROGRAMMING STATE* (WITH VIDEO DOOR PHONE STANDING BY ON-HOOK)
	Open pedestrian door	Open pedestrian door	Open pedestrian door	Open pedestrian door	Connect / disconnect the automatic door opening system
	—	Special function (default: 7)	Special function (default: 7)	Programmable intercom call 3 (Default: not programmed)	Adjust door phone and floor call volume (volume changes according to the following sequence: LOUD, LOW, MUTE)
	Auto power-on	Video switching	Special function (default: 8)	Programmable intercom call 2 (Default: not programmed)	Floor call ring tone (5 different ring tones)
	Garage door opener	Garage door opener	Garage door opener	Programmable intercom call 1 (Default: switchboard call)	Door phone call ring tone (5 different ring tones)

(*) To enter and exit programming state, hold button pressed for longer than 5 seconds. The yellow LED will blink slowly to indicate that programming mode is selected. Programming mode will shut down in all cases after the 10 minute timeout.

INDICATOR LEDS

Green LED on.
Indicates that a call is being received

Two-colour LED.

PRIORITY	FUNCTIONS
1	Rapidly blinking red: mute on
2	Green blinking: automatic door opener on
3	Red on steady: main calling station door open
4	Slowly blinking red: secondary calling station door open
5	Slowly blinking yellow: programming state on

information To save programming, remember to hold the button pressed for longer than 5 seconds to quit programming mode. In any case, after 10 minutes the system exits the programming state and saves the modified parameters.
Refer to the system booklet for how to program intercom calls.

RESET

To restore default parameters of the device after entering programming mode, hold button pressed for longer than 5 seconds, hold buttons and hold pressed for longer than 3 seconds. The system will emit two long beeps to confirm the command and exit the programming state.