Anritsu 680 C Series Operation Manual page 54

LOCAL (FRONT
PANEL) OPERATION
3-24
www.valuetronics.com
Scanning Tagged Frequencies–To go to the
Tagged Frequencies Menu (below) from the CW Fre-
quency Control menu, press Tag Freq Menu .
This menu lets you select the tagged frequencies for
output using the Scan Up and Scan Dn keys.
Return to the CW Frequency Control Menu display
by pressing Previous Menu .
Selecting a While in the CW frequency mode, you can edit the
Power Level current CW frequency output power level or enter a
new output power level.
Editing the Current Power Level
Press Edit L1 to open the power level parameter,
then edit the current power level using the cursor
control key or rotary data knob. To close the open
power level parameter, press Edit L1 or make an-
other menu selection.
Entering a New Power Level
Press Edit L1 to open the power level parameter,
then enter the new power level using the keypad
and appropriate terminator key. To close the open
power level parameter, press Edit L1 or make an-
other menu selection.
You can also select any of the preset
power levels or a power level sweep for a
CW frequency. For instructions, refer to
paragraphs 3-9 (Fixed Power Level Op-
eration) and 3-10 (Power Level Sweep
Operation).
CW FREQUENCY
OPERATION
NOTE
680XXC OM