Removing And Installing Parts; Before You Begin; Recommended Tools; Turning Off Your Computer - Dell Dimension 5150C Owner's Manual

Removing and Installing Parts

Before You Begin

This chapter provides procedures for removing and installing the components in your computer.
Unless otherwise noted, each procedure assumes that the following conditions exist:
• You have performed the steps in "Turning Off Your Computer" on page 55 and "Before
Working Inside Your Computer" on page 55.
• You have read the safety information in your Dell™ Product Information Guide.
• A component can be replaced or—if purchased separately—installed by performing the
removal procedure in reverse order.

Recommended Tools

The procedures in this document may require the following tools:
• Small flat-blade screwdriver
• Phillips screwdriver

Turning Off Your Computer

NOTICE:
To avoid losing data, save and close any open files and exit any open programs before you turn
off your computer.
1 Shut down the operating system:
Save and close any open files, exit any open programs, click the Start button, and then
a
click Turn Off Computer.
In the Turn off computer window, click Turn off.
b
The computer turns off after the operating system shutdown process finishes.
2 Ensure that the computer and any attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your operating system,
press and hold the power button for 4 seconds.

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to
help ensure your own personal safety.
Removing and Installing Parts
55