Removing And Installing Parts; Before You Begin; Recommended Tools; Turn Off Your Computer - Dell Dimension 9150 Owner's Manual

Removing and Installing Parts

Before You Begin

This chapter provides procedures for removing and installing the components in your computer.
Unless otherwise noted, each procedure assumes that the following conditions exist:
• You have performed the steps in "Turn Off Your Computer" and "Before Working Inside Your
Computer."
• You have read the safety information in your Dell™ Product Information Guide.
• A component can be replaced by performing the removal procedure in reverse order.

Recommended Tools

The procedures in this document may require the following tools:
• Small flat-blade screwdriver
• Phillips screwdriver
• Flash BIOS update program floppy disk or CD

Turn Off Your Computer

NOTICE:
To avoid losing data, save and close any open files and exit any open programs before you turn
off your computer.
1 Shut down the operating system:
Save and close any open files, exit any open programs, click the Start button, and then
a
click Turn Off Computer.
In the Turn off computer window, click Turn off.
b
The computer turns off after the operating system shutdown process finishes.
2 Ensure that the computer and any attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your operating system,
press and hold the power button for 4 seconds.
Removing and Installing Parts
63