Drive Interface Connectors
Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one
connector matches a tab or a filled-in hole on the other connector. Serial ATA cables go to the pin-1
end of the connector. The pin-1 end of a connector on a board or a card is usually indicated by a
silk-screened "1" printed directly on the board or card.
NOTICE:
the connector. Reversing the cable prevents the drive from operating and could damage the controller,
the drive, or both.
Serial ATA Connector
interface connector
Power Cable Connector
To connect a drive using the power cable, locate the power input connector on the system board.
Connecting and Disconnecting Drive Cables
When removing an IDE drive data cable, grasp the colored pull-tab and pull until the connector
detaches.
When connecting and disconnecting a serial ATA data cable, hold the cable by the black connector at
each end.
74
Removing and Installing Parts
When you connect an IDE interface cable, do not place the colored stripe away from pin 1 of
interface cable
power input
connector
power cable connector