Advertisement

Quick Links

PrimeLine
Torktumlare
T 8218 K
T 9253 E/K/VP
Installationsmanual
Använd inte denna apparat förrän du har läst dessa instruktioner!
Om den här maskinen byter äger så måste den här manualen följa
med maskinen.
01/2025
Produkt Nr. MGR0.1,
MWR0.1 , MTR0.1, MQR0.1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PrimeLine T 8218 K and is the answer not in the manual?

Questions and answers

Summary of Contents for Podab PrimeLine T 8218 K

  • Page 1 PrimeLine Torktumlare T 8218 K T 9253 E/K/VP Installationsmanual Använd inte denna apparat förrän du har läst dessa instruktioner! 01/2025 Om den här maskinen byter äger så måste den här manualen följa Produkt Nr. MGR0.1, med maskinen. MWR0.1 , MTR0.1, MQR0.1...
  • Page 3: Table Of Contents

    Innehåll / Content SVENSKA Säkerhet och skyddsåtgärder . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Transportera maskinen .
  • Page 4 4 SE...
  • Page 5 SE 5...
  • Page 6 6 SE...
  • Page 7 SE 7...
  • Page 8 8 SE...
  • Page 9 SE 9...
  • Page 10 10 SE...
  • Page 11 SE 11...
  • Page 12 12 SE...
  • Page 13 SE 13...
  • Page 14 14 SE...
  • Page 15 SE 15...
  • Page 16: English

    ENGLISH Symbols Please read the instructions . Warnings are marked with a warning triangle . The text gives information how a dangerous situation can be avoided . Signal words indicate the severity of the danger, if not avoided . Warning means that possible personal inju- ries, and potentially life-threatening injuries may occur .
  • Page 17: Safety And Safety Measures

    Safety and safety measures When installing and connecting Inexpert installation of hoses and the appliance, the following safety power cables may cause trip haz- instructions, warnings, general ards and danger of injury. instructions and any possible special Lay hoses and cables in such a ►...
  • Page 18: Transporting The Machine

    Transporting the machine The ventilation openings in the ► housing floor must not be ob- structed by carpeting. Important Operating temperature of the ► appliance is 5 to 35 °C. Warning Risk of fire! Risk of poisoning! Damage to goods and equipment! The device contains the environ- Maximum tilt of the machine to the mentally friendly, but flammable...
  • Page 19: Installing The Appliance

    Installing the appliance Fixing set For installation on slippery ground, e.g. installation base with tile surface, two self-adhesive receptacles secure the Notice machine from shifting. Do not install the dryer in an enclosed area or in any area without fresh air You can purchase the following fixing circulation.
  • Page 20: Aligning The Appliance

    Plastic fixing set – to be glued ► Important The machine must be placed with its back against a wall. Aligning the appliance Align the appliance with the help of ► a spirit level. Otherwise, the machine may wander and cause damage or lose condensation water.
  • Page 21: Washer-Dryer Tower

    Washer-Dryer tower Water outlet only applies to heat pump dryer and In order to save space (installation condensing dryer space), you can place your dryer on top of a washing machine (washer-dryer tower). It is absolutely imperative not The condensed water collects in the to mount a washing machine on a condensate pan and is pumped into dryer, risk of falling.
  • Page 22: Possibilities For Connection

    Possibilities for connection Washer-dryer tower ► When using the same siphon for the washing machine and the dryer, it Introduction of the condensate might become necessary to install a hose into a standpipe with siphon check valve on the back wall of the dryer.
  • Page 23: Exhaust Vents

    Exhaust vents Connecting the tube curve Included is a tube curve with a sep- arate sealing ring, clamping ring and only applies to exhaust-air dryer four screws. The connection possibilities for an exhaust air duct are located at the rear panel and on both sides of the appliance.
  • Page 24 Pressure loss Calculating the pressure loss The nature and length of the exhaust Notice air duct, in parti cular knee pieces or curves with small radii, impede the flow To ensure the minimum required air of air. flow, the total pressure loss must not Be sure to obstruct the air flow as little exceed the value of 150.
  • Page 25: Installing The Exhaust Duct

    Installing the exhaust duct Routing the exhaust air through a wall box into a fireplace or venti- lation shaft Depending on the structural situation, In the case of a connection to a venti- the exhaust air can be conducted in lation shaft insulated against moisture, different ways to the outside: the responsible chimney sweep is to be...
  • Page 26 Individual values for determining the total pressure loss (max. 150 ) Smooth Corrugated tubing tubing Straight piece each 1m long Tube curve Bending radius R = 100 mm Bending radius R = 200 mm Telescope wall box with grid Calculating the pressure loss of the exhaust air duct Smooth tubing Internal diameter ø...
  • Page 27: Electrical Connection

    Electrical connection Warning Risk of electric shock and risk of fire! Do not use an extension cable. Avoid ► Notice adaptors for multiple plugs in one Connection of the appliance to the socket and using multi-sockets. power supply must be carried out by a Do not use plug-in, mobile timer ►...
  • Page 28 För miljöns skull trycker vi endast i mycket begrän- © 2025 AB PODAB sad omfattning. Du kan hitta fler dokument och Vi förbehåller oss rätten att göra ändringar information om dina maskiner i informationsområdet och reserverar oss för eventuella tryckfel. för dina maskiner på www.podab.se...

Table of Contents