Podab ProLine TS 93 E Installation And Operation Manual

Drying cabinet

Advertisement

Quick Links

Installation and operation manual
Drying cabinet ProLine TS 93 E

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProLine TS 93 E and is the answer not in the manual?

Questions and answers

Summary of Contents for Podab ProLine TS 93 E

  • Page 1 Installation and operation manual Drying cabinet ProLine TS 93 E...
  • Page 2 Thank you for choosing the drying cabinet TS 93 E from PODAB. We hope that it will be of great use for you and ask you kindly to read the instructions carefully. FOR YOUR SAFETY, the information in this manual must be followed to prevent property damage and personal injury.
  • Page 3: Table Of Contents

    Requirements for incoming air Ventilation channel – design Evacuated amount of air and pressure fall User manual Automatic programs Select drying time manually Gentle drying Maintenance Take good care of the cabinet Ventilation system Keep your cabinet efficient and economical ©PODAB 2017...
  • Page 4: Safety Regulations

    IMPORTANT: to inform the reader of special steps that must be taken in order to prevent injuries on the cabinet. NOTE: to inform what is important to know, but it cannot cause personal injuries or injury on the cabinet. ©PODAB 2017...
  • Page 5: Important Safety Instructions

    17. Never try to manipulate or connect past any safety func- tions. 18. If the cabinet is not assembled after the manufacturer’s instructions, there is a risk that the cabinet can cause per- sonal injuries or injuries on property. ©PODAB 2017...
  • Page 6: Specification

    Heating effect, kW Total effect, kW Fuse, A Energy consumption, kWh * Part No 131034 *Drying of 12 kg cotton (dry weight), washed and high-spinned to 43% residual moisture. 15 minutes cool down excluded. Dried to 0% residual moisture. ©PODAB 2017...
  • Page 7: Assembly Instructions

    Assembly instructions Tools You need the following tools to easily install the drying cabinet, TS 93 E: • Cordless screwdriver • Wrench • Hex key 3 and 5 mm • Level • Torx screwdriver bit no. 25 ©PODAB 2017...
  • Page 8 ©PODAB 2017...
  • Page 9 (repeat step 3-5) ©PODAB 2017...
  • Page 10 ©PODAB 2017...
  • Page 11 ©PODAB 2017...
  • Page 12 ©PODAB 2017...
  • Page 13 ©PODAB 2017...
  • Page 14 ©PODAB 2017...
  • Page 15 ©PODAB 2017...
  • Page 16 ©PODAB 2017...
  • Page 17 ©PODAB 2017...
  • Page 18 Connect the cables Light (LIGHT) Relay board Reläkort Humidity sensor (HUMIDITY) Control board Temp sensor (NTC1) Relay board (X11) Door switch (DOOR) ©PODAB 2017...
  • Page 19 35 Nm ©PODAB 2017...
  • Page 20 ©PODAB 2017...
  • Page 21 ©PODAB 2017...
  • Page 22: Installation Of The Cabinet

    4 and control that the electrical connection is installed correctly. • Make sure that the ventilation channel is cleaned when a new cabinet is installed. • Use a 160 mm rigid or flexible metal duct to the evacuation connection. ©PODAB 2017...
  • Page 23: Requirements For Ventilation

    If the cabinet is placed in a room where the incoming air is not enough, we recommend that you install an air exchanger. Con- tact PODAB for more information. Ventilation channel – design IMPORTANT: Always make the channels as short as pos- sible.
  • Page 24: Evacuated Amount Of Air And Pressure Fall

    125 till 160 160 till 125 Air exchanger ø, mm Ø 12,5 Example: 10 m long 160 mm channel with 3 pipe curves which gives an estimated pressure fall of (10 x 1,5) + (3 x 4) = 27 Pa. ©PODAB 2017...
  • Page 25: User Manual

    If a program is interrupted before the cool down has finished, For delicate fabrics and synthetics gentle drying should be the inside of the drum could be very hot. used. The temperature is reduced. Activate gentle drying mode by pushing button 3 during program select. ©PODAB 2017...
  • Page 26: Maintenance

    Keep your cabinet efficient and econom- ical • The ventilation channels shall be as short as possible. • If possible, dry the same type of textiles at the same time. ©PODAB 2017...
  • Page 27: Podab

    ©PODAB 2017...
  • Page 28 SERVICE/SUPPORT Telefon 031 752 01 00 031 752 01 50 E-mail info@podab.se www.podab.se AB PODAB, Ekonomivägen 9, 436 33 Askim, SWEDEN Tel +46 (0)31-752 01 00, Fax +46 (0) 31-752 01 50, E-post: sales@podab.se, www.podab.se ©PODAB 2017-07-28...

Table of Contents