Related Manuals for DUSK GLCT02
Summary of Contents for DUSK GLCT02
- Page 1 Box dimensions: Box 1: L89 x W66.5 x L17 (cm) Box 2: L87 x W70 x L17.5 (cm) Glass Coffee Table (with Drawers) Up to 20 minutes Two person approx assembly assembly time Page 1...
-
Page 2: Care And Maintenance
Important Assembly Tip Before you begin, we advise laying everything out on a clean and soft level surface to avoid damaging the unit or your floor. It's best to identify all of the parts and fittings to build your bedside table, and to familiarise yourself with all of the parts and fittings before building. Top Tip We recommend that you build your new coffee table in the room you'd like it to be located. - Page 3 Parts Before you begin building your table, please take a moment to read through the instructions and make sure that you have all the relevant parts listed on the parts check list. Description Part Glass top 1 pc Cabinet bottom panel 1 pc Cabinet back panel 1 pc...
- Page 4 Step 1: Fit 18x cam lock screws (F) and 12x wooden dowels (E) to part 3, 4, 5 and 6. Wooden dowel 12 pcs Cam lock screw 18 pcs Step 2: Attach the cabinet back panel (3) to the cabinet bottom panel (2), fastening by 3x cam lock (G).
- Page 5 Step 3: Attach the left side panel (4) and the right side panel (5) of the cabinet to the bottom panel (2) and back panel (3), fastening by 8x cam lock (G). Cam lock 8 pcs Step 4: Attach the cabinet top panel (6) to the back panel (3) and two side panels (4, 5), fastening by 7x cam lock (G).
- Page 6 Step 5: Fit 8x cam lock screws (F) to drawer part 7 and 12. Attach drawer handle (D) to part 12, fastening by 2x screw (K). Drawer handle 1 pc Cam lock screw 8 pcs M4*10mm screw 2 pcs Step 6: Attach drawer side panels (8, 9) to front panel (12) with 4x cam lock (G).
- Page 7 Step 7: Insert the drawer bottom panel (10) and attach the center support bar (11) to drawer front panel (12), fastening by 2x cam lock (G). Cam lock 2 pcs Step 8: Attach drawer back panel (7) to part 8 and 9 with 2x cam lock (G) and 4x screw (J). Cam lock 2 pcs M4*30mm screw...
- Page 8 Step 9: Slide the drawer into the completed cabinet. Step 10: Flip the base support frame (13), 2x base support bar (15) and 2x base support bar (14) upside down and fasten by 16x bolt (B). M5*8mm Bolt 16 pcs M4 allen key 1 pc Page 8...
- Page 9 Step 11: Flip the completed drawer upright to fit it into the frame, securing it with 4x M6 bolts (A). M6*12mm Bolt 4 pcs M4 allen key 1 pc Step 12: Flip the glass top (1) to complete the frame. Page 9...
Need help?
Do you have a question about the GLCT02 and is the answer not in the manual?
Questions and answers