Stryker Prime Connect Quick Start Manual

Prime Connect
quick start guide
Step 1:
Zero the scale
Press and hold the Zero button until "Release" displays on
the screen.
Note: For the most accurate patient weight, lower the
backrest and Gatch so the patient surface is flat. For
products with foot end push handles, raise the foot end
push handles before you operate the scale system.
Warning:
• Do not use the scale system, electric lift, or electric litter options adjacent to or
stacked with other devices. If adjacent or stacked use is necessary, the scale
system, electric lift, or electric litter options should be observed to make sure
that all devices operate in the configuration in which they will be used.
• Do not operate the scale system while using the foot supports. Inaccurate
readings may occur.
Caution:
• Do not use the scale for patients under 50 lb (22.7 kg).
• Do not use the scale system reading as a reference for medical treatment.
scale system
TM
Step 2:
Weigh the patient
Once the patient is on the stretcher, press the scale button
(circled below) to generate the patient's weight.
lb/kg button
The patient's weight displays in kilograms. Press and hold the
lb/kg button to view the patient's weight in pounds.
Refer to your Prime Series Stretcher Operations Manual for additional product information:
1105-309-001 (Fifth Wheel)
1115-309-001 (Big Wheel)
1125-509-001 (Zoom Motorized Drive)
1105-069-003 AA.0 2025-01 Page 1