Table of Contents
Advertisement
Locate the SO-DIMM expansion port and proceed as follows:
5.
!
!
If you are replacing a SO-DIMM and need to remove one that is already installed,
do so as follows:
!
!
5-16 Using the System Drives and Bays
Hold the SO-DIMM at a 45 degree angle and align the SO-DIMM contacts
with the socket in the system. Push the connector into the socket.
Press down on the edge of the SO-DIMM opposite the contacts until the lock
tabs on the sides snap into place, securing the module.
Installing the SO-DIMM
Press the locking tabs away from the sides of the SO-DIMM and hold while
gently lifting on the edge of the SO-DIMM.
When the edge of the SO-DIMM pops up and is at approximately a 60 degree
angle, pull the SO-DIMM from the socket.
Advertisement
Table of Contents
