Table of Contents
Advertisement
T Mode Switch — Provides a four-position DIP switch for enabling/disabling
Vibration Detective Mode.
T Emergency Release Latch — Allows you to manually open the CD-R/RW drive
cover and remove a disc from the drive if the Open button function is disabled by
software or a power failure.
To open the cover and remove a disc in an emergency, slide the emergency latch on
the bottom of the drive.
Software and drivers for the CD-R/RW drive are provided separately on a CD. Printed
installation instructions are packaged with the CD.
Note
CD-R/RW drives ship with an NEC CD-RW Software CD. Install the software on your
system from this CD (see "NEC CD-RW CD" in Chapter 4.)
Using the USB CD-R/RW Drive
To use the USB CD-R/RW drive, follow these steps. Also refer to any instructions that
might come with the drive.
Connect the small end of the USB cable to the I/F port at the rear of the USB
1.
CD-R/RW drive. Connect the other end of the cable to the USB connector on your
notebook.
Connect the AC/DC power adapter to a 115 Vac power source. Plug the other end
2.
of the adapter into the DC IN connector on the rear of the drive.
3.
Slide the USB CD-R/RW drive power switch towards the rear of the drive to turn
power on.
Power on your notebook, if it is not already on. If this is the first time the USB
4.
CD-R/RW drive is connected, a New Hardware Found message displays on your
screen. Follow the prompts to install the hardware driver.
5.
Press the Open button on the top of the drive to open the CD-R/RW drive cover.
6.
Put your CD, printed side up, on the spindle in the drive.
Close the CD-R/RW drive cover. The CD autoplays if it has an auto start file. If it
7.
does not auto start, launch the CD from My Computer.
5-10 Adding Expansion Devices
CD-R/RW media must be formatted before you use it. Systems with USB
Advertisement
Table of Contents
