Setup Keys; Changing/Setting Parameter Settings; Setup Key Functions - NEC VERSA 6000 Series Service Manual

Setup Keys

Refer to Table 2-5 for a description of Setup Key functions.
Key
Tab
Up or down arrow
Pg Up/Pg Down
-–/+
F9
F10
Esc
Enter

CHANGING/SETTING PARAMETER SETTINGS

Use the following steps to set or change parameter settings:
1. Select a parameter menu from the menu bar by moving the cursor to the word
that represents the screen you want to display.
For example, to select "Peripherals," press the arrow key until the word Peripher-
als is highlighted. A screen appears with the current setting for each peripheral
device.
View the parameter settings by pressing the space bar or the + key. The choices
2.
appear, toggling from one to another as you press.
When you reach the setting you want, leave it and move to the next parameter to
3.
be changed.
When you are through viewing or changing parameters, press ESC to move to
4.
the Exit screen.
The Exit screen displays a list of options. Press Enter to select "Save Changes
5.
and Exit". The screen displays a prompt confirming that the changes were made.
Table 2-5 Setup Key Functions
Function
Moves cursor to another field in the menu. For example, pressing
Tab moves the cursor up or down a list of current parameters.
Moves the cursor between the displayed parameters.
Moves to previous/next page on scrollable menus.
Selects lower/higher value.
Loads factory-installed Setup default values for the displayed
parameters only.
Restores previous values from CMOS.
Displays the Exit screen
Selects the parameter sub menu.
NOTE: Selecting incorrect values may cause a
system boot failure. Load Setup default values to
recover.
Setup and Operation 2-21