NEC SILENTWRITER SUPERSCRIPT 660 User Manual page 53

7. Tell the setup program which parallel port you
wish to use: LPT1, LPT2, or LPT3. The setup
program only shows you the port names avail-
able on your system. The default is LPT1.
Later, after the installation, you can select a
different port by using the NEC SuperScript
Print Status Window (see Chapter 5).
8. Tell the setup program which drive and directory
you want to install the NEC SuperScript soft-
ware. You can accept the default supplied by the
setup program, or give it the name of another
drive on your PC on which to install the soft-
ware. You should select a drive with at least the
amount of free disk space (7.1 megabytes)
required for the NEC SuperScript installation.
As shown in the next figure, "Setup Directory
Selection", the setup program will create and set
up the directory "C:\SSCRIPT" as the default
installation directory. You can change the
default directory at this time by specifying a
different directory.
Setting Up 2–33