Table of Contents
Advertisement
IDE Interface (Primary and Secondary)
The Primary and Secondary IDE Interface fields enable the
IDE interface connectors on the system board. These fields
can be either "Auto Configured" detected or "Disabled."
The default is "Auto Configured."
Floppy Interface
The Floppy Interface field enables the diskette drive
interface connector on the system board. This field can be
either "Auto Configured" detected or "Disabled." The
default is "Auto Configured."
Serial Port (1 and 2) Address
The serial ports 1 and 2 may be "Auto Configured" detected
or "Disabled." The default is "Auto Configured." When
"Auto Configured" is selected, the first free Serial port is
assigned regardless of what is selected.
The serial COM port and addresses are as follows. When
an option is selected for one serial port, the selection is not
available for the second port.
T
Disabled
T
COM1, 3F8h, IRQ4
T
COM2, 2F8h, IRQ3
T
COM3, 3E8h, IRQ4
T
COM4, 2E8h, IRQ3
Serial Port 2 IR Mode
The Serial Port 2 IR Mode field allows you to dedicate
Serial Port 2 for Infra-red applications. This field can be
either "Enabled" or "Disabled." The default is "Enabled."
4-16 Setting System Parameters
Advertisement
Table of Contents
