Changing Jumper Settings - NEC POWERMATE ENTERPRISE - 10-1997 Manual

NOTE
after the BIOS Recovery procedure finishes, turn off
the computer, set the configuration jumper to
Normal Mode, and turn on the computer.

CHANGING JUMPER SETTINGS

To change processor jumper settings, follow these steps.
NECCSD recommends using needle-nose pliers to move a
jumper.
The system power must be off before changing a
jumper setting.
Power off and unplug the system and any peripherals.
1.
2. Remove the system unit cover (see "Removing the
System Unit Cover" in Chapter 5).
3. Locate the configuration jumper J1A1 pins 1, 2, and 3
on the system board (see "Locating the System Board
Jumper").
If you need to change a jumper setting, lift the plastic
4.
block and place it on the appropriate pins.
Replace the system unit cover (see "Replacing the
5.
System Unit Cover" in Chapter 5).
Reconnect the system and monitor power cables and
6.
peripheral devices.
Power on the system.
7.
6-6 Setting System Board Jumpers
For the configuration changes to take effect
!
WARNING