NEC POWERMATE 2000 - RELEASE NOTES 06-2001 Release Note page 4

The following procedure describes how to disable the NetBEUI and NWLink protocols, enable
TCP/IP, and provide network, domain, and gateway information. (If a different protocol is
enabled, the menu choices might differ from those described in the procedure.)
From the Windows desktop, click
1.
Panel .
Double click the
2.
Click the
3.
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
Highlight
4.
appears asking for confirmation to continue.
Click
5. Yes
disappear from the Protocols display.
Repeat steps 4 and 5 to remove the NetBEUI Protocol.
6.
7. In the Protocols tab display, click
The TCP/IP Setup window appears. If there is a DHCP server on the network, click
8.
otherwise click
9. Change the path in the window to
If Yes was clicked in step 8, skip to step 16. If No was clicked in step 8, the Windows Setup
window appears.
10. Click Close
Fill in the
11.
address" area.
Click the
12.
13. Click the
14. Click the
Click the
15.
16. Click OK
Changing Network Settings on Systems with the Windows 2000 Operating
System
The Windows 2000 operating system installs TCP/IP during setup if the typical network settings
were chosen. However, before you connect a system to your network you might need to:
T
enable a different network protocol
T
disable unneeded protocols for enhanced system performance
T
add or change network, domain, and gateway information.
The following procedures describe how to modify installed protocols and how to provide
network, domain, and gateway information. (If a different protocol is enabled, the menu choices
might differ from those described in the procedure.)
4 NEC PowerMate 2000 Series Release Notes
Start
icon in the Control Panel window.
Network
tab. In the display, the following protocols are loaded:
Protocols
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink NetBIOS lines
Add,
.
No
C:\I386
. The Microsoft TCP/IP Properties Box appears.
, the Subnet
IP Address Mask
tab and enter the host and domain name in the DNS display.
DNS
Identification tab and change the Computer Name if appropriate.
WINS tab and enter the WINS address if appropriate.
tab and enable IP forwarding if appropriate.
Routing
. When prompted to restart the system, click
on the taskbar, point to
Settings
and click
Remove
highlight TCP/IP , and click
. Click Continue . The Network window appears.
, and the
Default Gateway
Yes .
, and click
Control
. A warning window
OK .
;
Yes
in the "Specify an IP