Replacing Mini-Card; Internal Card With Bluetooth ® Wireless Technology; Removing The Card - Dell PP29L Owner's Manual

Replacing Mini-Card

NOTICE:
check the connectors on the card and on the system board, and realign the card.
NOTICE:
1 Insert the card connector into the system board connector at a 45-degree angle.
2 Press the other end of the card down into the slot on the system board
until the card clicks into place.
3 Replace the securing screw.
4 Connect the cables to the Mini-Card, ensuring that you route the cables
correctly.
NOTE:
connector, see the documentation that came with your Mini-Card.
5 Secure unused antenna cables in the protective mylar sleeve.
6 Replace the cover and tighten the eight captive screws.
Internal Card With Bluetooth
Technology
CAUTION:
safety instructions in the Product Information Guide.
NOTICE:
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
If you ordered a card with Bluetooth wireless technology with your computer,
it is already installed.

Removing the Card

1 Follow the procedures in "Before You Begin" on page 107.
2 Remove the hinge cover (see "Hinge Cover" on page 113).
3 Remove the screw securing the card.
122
Adding and Replacing Parts
The connectors are keyed to ensure correct insertion. If you feel resistance,
To avoid damage to the Mini-card, never place cables under the card.
For more specific information about which cable to connect to which
Before you begin any of the procedures in this section, follow the
To avoid electrostatic discharge, ground yourself by using a wrist
®
Wireless