Becker EC3111 Programming Manual

Programming with a built-in roller shutter receiver :
1. Go with the new remote next to your roller shutter in a distance of 1 m.
2. Cut the power supply to the receiver and turn on the power again after 5 seconds
3. In the following minutes, press the programming button P (see fig 1), on the back of the new
remote for 3 seconds. The roller shutter makes a short fore-aft movement.
4. Your new remote control is now programmed
Programming with an external receiver :
Attention! : If you hold down the programming button for too long, you will delete all previously
stored remotes.
1. Open the housing of the receiver. It is located near the engine or under the motor cover.
2. Press the programming button (ENR, MEMO, PROG REC ... depending on the model) on the
receiver board and release the button.
3. The LED on the receiver will light or flash.
4. Press a button on the new remote for 1 second.
5. Release the button. The LED on the receiver goes off immediately or in the next 10 seconds.
(Depending on model)
6. Your new remote control is now programmed
http://www.remotecontrol-express.com
Programming Manual
BECKER EC3111
Fig 1
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151