Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Audient ORIA
Summary of Contents for Audient ORIA
- Page 1 Dante Card Installation Guide...
- Page 2 2. Remove the lid by removing the 14 screws on the top panel with a Phillips screw driver. 3. Remove the rubber network port cover from the rear panel of the ORIA. DO NOT throw this cover away as it may be needed again.
- Page 3 4. Behind the Network Port, there are three silver, hexagonal posts protruding from the board which we refer to as stand-offs. Three screws will be provided with the Dante Card. Place the network card on top of the stand-offs and use the screws to mount the network board.
- Page 4 6. Put the lid back on and screw it back down firmly. Important Note: If at any point the network board is removed from the ORIA unit, the rubber port cover must be refitted. If the cover is not fitted then the unit may not meet local safety regulations.
Need help?
Do you have a question about the ORIA and is the answer not in the manual?
Questions and answers