Alpha Moisture Systems DS1200 User Manual page 8

Model DS1200-AMT-Ex
4. Wiring
4.1 Model DS1200 Power Supply
• Connect the power supply cable to the green 2 terminal block marked 31 and
32 (no polarity).
• The power supply should be 22 to 253 VAC @ 50/60Hz or 20 to 300 VDC
4.2 Model AMT-Ex connec
• Refer to Sec
signal isolator and wiring from the signal isolator to the Model DS1200 display
unit. Route the signal cable to the intended site of the Model AMT-Ex.
Note : -
Do not install the sensor at this
described later
4.3 Alarm Cable
• Make the appropriate connec
closed relay contact posi
4.4 Analogue Output Cable
• Make the appropriate connec
maximum load specifica
4.5 Rear Connec
6
on via PR5104BB2A (or B)
on 11, Appendix A and B for wiring the Model AMT-Ex to the
ons, no
ons.
ons, ensuring that the correct polarity and the
on is strictly observed.
ons:
me. Wait un l the commissioning stage as
ng the normally open and normally
2148 - Iss 6 - 10/23