SMC Networks BARRICADE SMC7301TA User Manual page 41

Step 1: Set any of the following parameters:
Data Service: choose 64K, 56K, or Auto. Select Auto unless you know the
speed required by the other end of the con nection requiring either 64K or 56K.
Remote Sub-Address: Enter sub-address number in the remote site if
necessary.
Caller ID Authentication: select Yes if you want the SMC7301TA to check
the caller ID before accepting the call. This service may require a special
agreement with your ISDN service provider.
Caller ID Number: if you enabled Caller ID Authentication, enter the expected
Caller ID Number in this field.
STAC Compression: allows outgoing data to be compressed to achieve
higher throughput, and compr essed incoming data to be recognized. The
ability to use compression depends on the capabilities of the ISP.
Idle Timeout: the number of seconds of inactivity over the connection. When
this value is reached, SMC7301TA will disconnect the call. You can set the
idle timeout from 0 to 3600 seconds. The default setting is 120 seconds. If you
select 0, the connection will never be timed out.
Enable IP: select Yes to allow IP routing over a connection using this profile.
IP RIP: enable or disable IP Routing Infor mation Protocol. Available RIP
options are RIP1 and RIP2
Remote IP Address: the IP address of a destination computer on a network
reachable through this connection.
Remote IP Netmask: the IP subnet mask of the Remote IP Address.
Enable Bridging: select Enable to bridge other protocols, for example, SNA,
41