SMC Networks BARRICADE SMC7301TA User Manual page 52

Enter the following information:
Rule No.: a number used for identification purposes.
Rule Name: a name by which you will refer to this rule.
Interface: the specific WAN interface this new selection rule will apply to.
IP Protocol: The IP protocol that this new selection rule will apply to.
Available options are Any, TCP, UDP, ICMP, and IGMP.
Local IP Address: the IP address(es) of the local devices this new rule will
apply to. You can select a single IP address, a range of IP addresses, a
network, or any IP addresses. The screen may change to show fields you
need to fill out accordingly. For example, if you select a range, you will also
see (From) and (To) fields where you need to fill out the starting IP address
and the ending IP address.
Local Port: the port number(s) of the local devices this new rule will apply to.
Remote IP Address: the IP address(es) of the remote devices this new rule
will apply to. You can select a single IP address, a range of IP addresses, a
network, or any IP addresses. The screen may change to show fields you
need to fill out accordingly. For example, if you select range, you will also see
(From) and (To) fields where you need to fill out the starting IP address and
the ending IP address.
Remote Port: the port number(s) of the remote devices this new rule will
apply to.
A
If you highlighted an existing entry in the IP Filtering Configuration
window and clicked Edit instead, a similar screen will display, with all fields
already filled out previous ly. Then you can make changes if necessary. If you
highlighted an existing entry and clicked Delete instead, the corresponding
entry in the rule table will be removed.
52