1000Base-T Ports; Led Status Indicators - SMC Networks FS26 Installation Manual

Introduction

1000BASE-T Ports

The two 1000BASE-T RJ-45 ports operate at 10 Mbps or 100 Mbps, half or full
duplex, or at 1000 Mbps, full duplex. Because these ports support automatic
MDI/MDI-X operation, you can use straight-through cables for all network
connections to PCs or servers, or to other switches or hubs.

LED Status Indicators

The front panel of the switch provides status LEDs for "at-a-glance" system
monitoring. The following table details the functions of the various indicators.
LED
Power
Ports 1-24
Link/Act
10/100/1000
2
Port and System Status LEDs
Condition Status
On The switch is receiving power.
Off The switch is not receiving power.
On The port has established a valid network
connection.
Off The port has not established a network
connection.
Flashing Traffic is passing through the port.
On Green Indicates the port is operating at 100 Mbps.
Off When the corresponding Link/Act LED is on,
indicates the port is operating at 10 Mbps.
Amber Indicates the port is operating at 1000 Mbps (port
25,26)