Table of Contents
Advertisement
M
N
AKING
ETWORK
Fiber Optic XFP Devices
A 10 Gigabit XFP transceiver (10GBASE-SR, 10GBASE-LR, or
10GBASE-ER) can be used for a backbone connection between switches,
or for connecting to a high-speed server. For information on installing
fiber optic XFP transceivers, refer to the following description.
Each single-mode fiber port requires 9/125 micron single-mode fiber
optic cable with an LC connector at both ends. (See "Connectivity Rules"
on page 4-6 for information on the connector types required for specific
XFP transceiver types.) Each multimode fiber optic port requires 50/125
or 62.5/125 micron multimode fiber optic cabling with an LC connector at
both ends.
Warning:
Note: When selecting a fiber XFP device, considering safety, please make
sure that it can function at a temperature that is not less than the
recommended maximum operational temperature of the product.
You must also use an approved Laser Class 1 transceiver.
Hinweis: Bei der Wahl eines Glasfasertransceivers muß für die
1. Remove and keep the LC transceiver port's rubber plug. When not
connected to a fiber cable, the rubber plug should be replaced to
protect the optics.
4-4
C
ONNECTIONS
This switch uses lasers to transmit signals over fiber optic
cable. The lasers are compliant with the requirements of a
Class 1 Laser Product and are inherently eye safe in normal
operation. However, you should never look directly at a
transmit port when it is powered on.
Beurteilung der Gesamtsicherheit beachtet werden, das die
maximale Umgebungstemperatur des Transceivers für den
Betrieb nicht niedriger ist als die für dieses Produkts. Der
Glasfasertransceiver muß auch ein überprüftes Gerät der Laser
Klasse 1 sein.
Advertisement
Table of Contents
