SMC Networks 7208SBR User Manual page 7

LEDs (Front Panel)
Page 4
Reset IP Button
(IP/Password)
WAN Port
Printer Port
Serial Port
There are five (5) status LEDs on the front panel, as follows:
Ready Normally ON.
This blinks during Startup or Shutdown, and turns OFF after the
shutdown is completed.
Error Normally OFF.
However, it will be On during the power-on self test. Once the
(Amber)
self-test is completed, it will turn OFF. If it stays ON, there is a
hardware error.
During a software upgrade, both the Ready and Error LEDs
will blink.
Disk Full Normally OFF.
Blinking indicates the disk is 98% full.
ON indicates the disk is completely full.
Disk Flashes during normal operation, when the Hard Disk is ac-
cessed.
WAN Flashes when data is transmitted or received via the WAN
(Internet Access) port
If the Barricade's IP Address or password is lost, press and
release this button. The Barricade will beep once to indicate
the reset has occurred.
The Barricade password will be cleared, and its IP Address
set to the default value of 192.168.123.254, with a Network
Mask of 255.255.255.0
You can then connect to the Barricade and set the correct IP
Address and password.
Connect your ADSL or Cable modem here.
This Ethernet port supports 10BaseT and 100BaseT, and has
2 built-in LEDs. The amber LED (on the left) indicates a
100BaseT connection. The green LED (on the right) indi-
cates a 10BaseT connection.
Standard parallel printer port. A printer connected here
becomes a "network printer", and can be shared by Win-
dows and Macintosh users.
Standard serial port. Connect an analog modem or ISDN TA
here if you wish to provide shared Internet access to LAN
users via the serial port.