Aiwa XR-MT1000 Operating Instructions Manual page 31

22
35
S'TOP
um
S,et the tape
to
the point where recording will start,
The reverse mode is automatically set to =.
Note that recording will be done on one side of the tape only.
1
2
3
4
5
Press TAPE on the stereo receiver.
Insert the original tape into deck 1 and the tape
to be recorded on into deck 2.
Insert the tapes with the sides to be played back or recorded
on facing out from the unit.
Press DOLBY NR to turn off the Dolby NR.
CYCINR on the display of the stereo receiver disappears.
Press TAPE on the stereo receiver to select deck
1.
"TP 1" is displayed.
Press @ REC/REC MUTE to start recording.
Playing and recording start simultaneously.
To
stop dubbing
Press STOP (or CLEAR on the remote control).
To set the Dolby NR when playing back the dubbed tape
Press DOLBY NR and turn Dolby NR on or off to match the
ori!ginal tape.
22
3
S'TOP
This function allows you to make exact copies of both sides of
the original tape. The reverse side of both tapes will start
simultaneously as soon as the longer tape has been reversed.
m
Dubbing does not start from a point halfway in the tape,
The reverse mode is automatically set to Z).
The Dolby NR does not affect recording.
1 Press TAPE on the stereo receiver.
2 Insert the original tape into deck 1 and the tape
to be recorded on into deck 2.
s?
Insert each tape with the side to be played back or recorded
on facing out from the unit.
/j#:,
-#j:g
3 Press SYNC DUB once or twice to start recording. #~
O
For recording at normal speed, press it once to display :~,. ~~~
NORM-DUB.
k ,,:,"" ~$
&
k, .:;'
@
For recording at high speed, press it twice to display :' ~
HIGH-DUB.
The tapes are rewound to the beginning of the front sides,
and recording starts.
To stop dubbing
Press 9STOP (or CLEAR on the remote control).
m
To
set
the
Dolby NR when playing back
the
dubbed tape
Press DOLBY NR and turn Dolby NR on or off to match the
original tape.
m
Recording does not start, if the erasure prevention tab on either
side of the tape to be recorded on is broken off.
—
To
erase a recording
Make sure the microphone is not connected to this unit and the
RFlythm play function (page 14) is canceled.
1 Insert the tape to be erased into deck 2 and press TAPE on
the stereo receiver to display "TP 2".
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing REV MODE.
4 Press REC/REC MUTE to start the erasure.
ENGLISH
31