Aiwa XR-MT1000 Operating Instructions Manual page 17

1
2
3
p~e~~
cLocKmMER
once then
—
Y
within 6 seconds.
press ENTER
Turn MULTI JOG to designate the hour, then press
ENTER.
l-he hour stops flashing and the minute starts flashing.
Turn MULTI JOG to designate the minute, then
press
ENTER.
l-he minute stops flashing on the display and the clock starts
from 00 seconds.
To :switch to the 24-hour standard
Press the CLOCIUTIMER and then press MULTI JOG within 6
seconds.
Repeat the same procedure to restore the 12-hour standard.
[
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If [power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
*
CLOCK on the remote control is also available instead of CLOLW
TIMER.
* IISET on the remote control is also available instead of ENTER.
_ W or W on the remote control is also available instead of MULTI
JOG.
The unit can be turned off automatically at a specified time.
Use the remote control.
1
2
Press SLEEP.
"SLEEP" appears.
Within 4 seconds, press ++ or _ to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press SLEEP m. The remaining time is displayed for 4
seconds.
m
To cancel the sleep timer
Press SLEEP @!Ice so that "SLEEP on the display disappears.
ENGLISH I
7