Aiwa XR-MT1000 Operating Instructions Manual page 21

II 3 2
0-9,+10
TUNER
BAND
Preset number
4
I?epeat steps 1 to 3.
l-he next station will not be stored if a total of 32 preset stations
for all the bands have already been stored.
m
If power is interrupted for more than approximately 24 hours,
preset stations stored in memory after purchase need to be reset.
1
2
2
TU!NING
V,A
Press TUNER BAND to select a band.
Press numbered buttons O-9 and +1 O to select a
preset number.
B
"PRESET NO." appears in the display,
U)
Example:
To select preset number 20, press +10, +10 and 0.
To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
1 Press TUNER BAND to select a band.
2 Press TUNING/PRESET repeatedly so that "PRESET NO."
appears on the display.
3 Press TUNING V or TUNING A to select a station.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
SET. The frequency flashes. Then press SET again within 4
seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER BAND.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
ENGLISH 21