Adjusting Volume; Switching On / Off; Switching The Display Mode; Selecting Operating Mode - VDO MR6000 Owner's Manual And Mounting Instructions

6. OPERATION
Basic operation
Note:
• Switch on the unit when the engine is running.
• Do not use the unit for long time periods with
the engine switched off. It may no longer be
possible to start the engine if the battery has
been overloaded. The service life of the battery
will also be shortened.

Switching on / off

1. Switch on the unit via FUNC button 1.
2. The illumination and the display of the unit
are activated. The unit automatically stores
the last operating mode to be set and auto-
matically sets this operating mode on the
display.
3. Press and hold the FUNC button for at least 1
second to switch off the unit.
Note:
• System check
After installation and completion of all wiring
connections, an automatic system check is per-
formed before the system can be operated for
the first time. After connection to the vehicle
power supply, the displays "SYSTEM" and
"PUSH PWR" appear alternately on the moni-
tor.
Press the FUNC button 1 .
The system now performs a system check. As soon
as "COMPLETE" appears, press the FUNC button
again.

Selecting operating mode

1. Press the FUNC button 1 to change the op-
erating mode.
2. Each time the FUNC button is pressed, the
operating mode is changed in the following
sequence:
Radio operation –> CD changer –> Televi-
sion operation –> Radio operation ...
Note: Please refer to the diagrams on page 3 (fold out) when rea-
ding this section.

Adjusting volume

Move the VOL button 2 in the direction of
the arrow 8 8 8 8 8 (upwards) or 2 2 2 2 2 (downwards) to
adjust the volume.
8 8 8 8 8 : Increases the volume
2 2 2 2 2 : Decreases the volume
The volume level shown on the display covers a range from
0 (minimum) to 33 (maximum).
The volume should be set so that outside
noises (e.g. emergency vehicles) remain audi-
ble.

Switching the display mode

Retracted unit:
Actuate the DISP button b to set the desired
display mode. Each time the DISP button is
actuated, the display mode is changed in the
following sequence:
Note:
• Once the desired display mode is set, this be-
comes the standard mode. When a function
setting is performed, e.g. for volume, the unit
switches temporarily to the mode for the func-
tion. The unit switches back to the desired mode
a few seconds after setting.
CAUTION
MAIN mode
SUB mode
Time mode (CT)
MAIN mode
17