Adjusting Bass And Treble; Ct Function (Time); Adjusting Balance And Fader - VDO MR6000 Owner's Manual And Mounting Instructions

Basic operation

Adjusting bass and treble

Note:
• This function is only available with the unit
extended.
• This function is only available when the sound
processor is switched off ("Z-EHCR off").
1. Press the AUDIO button g to switch to AU-
DIO operating mode.
2. Press the JOYSTICK k upwards or down-
wards to select "BAS/TRE". Press the enter
button in the centre of the JOYSTICK to re-
call the setting menu BASS/TREBLE.
3. Press the JOYSTICK to the right or left to re-
call either the bass ("BASS") or treble ("TRE-
BLE") level.
4. Press the JOYSTICK upwards or downwards
to set the level (setting level: -6 to 6).
5. After setting, press the JOYSTICK to the right
or left to access "MENU". Subsequently, press
the enter button in the centre of the JOY-
STICK to switch to AUDIO operating mode.

Adjusting balance and fader

Note:
• This function is only available with the unit ex-
tended.
1. Press the AUDIO button g to switch to AU-
DIO operating mode.
2. Press the JOYSTICK k upwards or down-
wards to select "BAL/FAD". Press the enter
button in the centre of the JOYSTICK to re-
call the setting menu BAL/FAD.
3. Press the JOYSTICK to the right or left to set
either the balance of volume between the
right and left level channels ("BALANCE")
or between front and rear channels
("FADER").
4. Press the JOYSTICK upwards or downwards
to accept the setting.
Setting range for balance: L13 to R13
Setting range for fader: Front 12 / Rear 12
5. After setting, press the JOYSTICK to the right
or left to access "MENU". Subsequently,
press the enter button in the centre of the
JOYSTICK to switch to AUDIO operating
mode.
20
Loudness
The loudness function increases treble and
bass in order to create a natural tone. Loud-
ness should be switched on when listening to
music at low volume.
• This function is only available with the unit
extended.
1. Press the AUDIO button g for at least 1 sec-
ond to activate the loudness function. "LD"
illuminates on the display.
2. Press the AUDIO button again for at least
1 second to switch off the loudness function.
"LD" extinguishes on the display.

CT function (time)

The CT function receives CT data from an RDS
station and the time is displayed. Actuate the
DISP button b in order to set the CT display.
* If no CT data is received, "CT --:--" appears on the display.
Note:
• CT data is not transmitted in certain countries
and by certain stations. CT data cannot be cor-
rectly displayed in certain regions.