Recording Of A Cd - Aiwa XR-MD95 Operating Instructions Manual

PROGRAMMED RECORDING OF
A CD
Up to 30 tracks can be programmed and recorded on an MD.
0-9,+1 o
PRGM I
CD>MD
DISPLAY
CD
1 Load a recordable MD into the disc drive with the
label side up and in the direction of the arrow.
Direction guide
I
2 Press the CD button on the control panel.
3 Load the CD to be recorded.
4 Press the PRGM button while pressing the SHIFT
button on the remote control.
"PRGM" appears on the display.
5
6
7
Press the numbered button and the +10 button
to program a track to record.
Example:
To select the 12th track, press the +10 and 2 buttons,
To select the 20th track, press the +1 O, +1 O and O buttons.
Selected track number Program number
r-l
v'
Total number of Total playing time of
selected tracks the selected tracks
Repeat step 5 to program other tracks.
Press the CD * MD button to start recording.
Recording begins,
When the programmed tracks finish playing, the recording
stops automatically,
Then, "TOC Edit" appears on the display and the contents
(TOC) of the recording are recorded on the MD.
To stop recording halfway
Press the button. Recording stops, and the contents (TOC)
of the recording are recorded on the MD.
To stop play of the CD, press the button again.
To record on a previously recorded
MD
If there is an unrecorded section left on the MD, the new recording
automatically starts from where the previous recording finished.
If you want to start recording from the beginning of a previously
recorded MD, erase the previous recording completely. (See
page 26.)
To change the display during recording
Press the DISPLAY button. With each press of the button, the
display changes in the following order.
[
@
Track number and elapsed time of CD
(Example: CD lTr
1:23)
[2)
Track number and elapsed time of MD
(Example: MDllTr
1:23)
~
Remaining recordable time of MD
(Example: MD
–36: 15)
ENGLISH 19