Aiwa XR-M75 Operating Instructions Manual page 7

VOLUIME CONTROL
Turn VOLUME on the main unit, or press VOLUME
on the remote control.
The volLlme level is displayed as a number from O to MAX (31).
The volume level is automatically set to 16 when the power is
turned off with the volume level set to 17 or more.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press l-BASS.
Each time it is pressed, the level changes. Select one of the
three levels or the off position to suit your preference.
""
5/"4+$+1
J
T-BASS
T EAM T-BASS T.L7ASS
I
(cancel)
To select with the remote control
Press T=BASS while pressing SHIFT.
Low frecp_rency sound maybe distorted when the T-BASS system
is used tor a disc or tape in which low frequency sound is already
emphasized. In this case, cancel the T-BASS system.
To dim the illumination of the display
1
Press
CLOCWDIMMER -, then press ENTER within 4
seconds.
2 Within 4 seconds, turn MULTI JOG to select the dimmer mode.
r
DIMMEROe DIMMER
1- DIMMER z -
DIMMER3
-1
DIMMEIR O: The usual display.
DIMMEIR 1: The illumination of the display is dimmer than usual.
DIMME!R 2: The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3: The illumination of the display is dimmer than
DIMMER 2. The spectrum analyzer and the
illumination on the buttons also light off.
+ U
and W are also available instead of MULTI JOG.
i
:,.
—r
This unit provides the following three different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
CLASSIC: Enriched sound with heavy bass and fine treble.
Press GEQ repeatedly to select the equalization
mode.
The GEQ mode is displayed cyclically as follows.
r
ROCK— POP — CLASSIC— GEQ OFF
(cancel) 1
The selected equalization mode is displayed.
To cancel the selected mode
Press GEQ repeatedly until "GEQ OFF is displayed.
To select with the remote control
Press GEQ repeatedly while pressing SHIFT.
*
MULTI JOG
is
also available to change the equalization mode,
Using the headphones
Connect headphones to PHONES jack with a standard stereo
plug (a6.3 mm, '/4 inch).
No sound is output from the speakers while the headphones are
plugged in.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
ENGLISH
6