Aiwa XR-M75 Operating Instructions Manual page 12

$
'*———— -—-————$' '
I
.,
Preparation
Use Type I (normal) tapes only.
Set the tape to the point where recording will start.
Note that recording is done on only one side of the tape.
1 Insert the tape to be recorded on into Deck 1,
Insert the tape with the side to be recorded on first facing out
from the unit.
2
m----- ---- _f -L- - . ...-1.--- L..mL ---- -.__l .. ... .. . ..-
3
rress one or me wncuon muons ana prepare
the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a ta~e, press TAPE. Then, insert the original
tape into Deck 2 and play it.
To record from a radio broadcast, press TUNEWBAND and
tune in to a station.
To record from a connected source, press VIDEO/AUX/
PHONO and play.
Press on Deck 1 to start recording.
>
is depressed simultaneously.
When the selected function is CD, playback and recording
start simultaneously.
LE!M
.
To stop recording, press 9/4 on Deck 1.
To pause recording, press II on Deck 1.
To resume recording, press it again.
To record selected tracks of the CD
Before pressing , program the tracks (see page 10).
To record part of the
CD
When is pressed, recording always starts from the first track.
To start in the middle of a track, play th~ CD first and press I I SET
for CD at the point you wish to start recording from. Then, press
. The pause mode for CD button is released automatically
and recording
Stark.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
Do not press the buttons on Deck 2 during recording.
cannot be depressed if the erasure prevention tab on the
side of the tape to be recorded is broken off.
To erase a
recording
A previous recording is erased when a new recording is made
on that part of that tape.
1 Insert the tape you want to erase into Deck 1.
2 Press TAPE and stop all the tape operation in Deck 2.
3 Windup the tape to the point where the erasure is to be started.
4 Press on Deck 1 to start the erasure.
About cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Tab for side A
To record on the tape again, cover the tab openings with
adhesive tape, etc.
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break orjam in the mechanism.
I 1
ENGLISH