Aiwa XR-M75 Operating Instructions Manual page 11

wjoadina an 8-cm (3-inch) disc, make sure to riace it onto
~rer circle of the tray precisely. Otherwise, the disc may
be damaged or the disc compartment will not open. If it does
not open, please consult your Aiwa dealer for repair.
Do not place more than one compact disc on one disc tray.
Do not tilt the unit with discs loaded. Doing so may cause
malfunctions.
When transporting the unit, remove the discs from the trays.
When replacing the discs during play, do not replace discs other
than those facing you.
If you Iplace a disc on the empty right inner tray, and then press
A OPEN/CLOSE, "ERROR" is displayed and the disc
compartment may not close. Remove the disc on that tray.
/
b
c=
ce here,
—.
\
i
Use the remote control
13AND(3M play
All the tracks on the selected disc or all the discs can be played
randomly.
REPEAT play
A single disc or all the discs can be played repeatedly.
Press FtANDOM/REPEAT while pressing SHIFT.
Each time it is pressed, the function can be selected cyclically.
RANDOM play — RANDOM lights up on the display.
REPEAT play — ~ lights up on the display.
RANIDOM/REPEAT play — RANDOM and ~ light upon the
displi~y.
Cancel — RANDOM and ~ disappear from the display.
To play-all discs, press * to start play.
=.a sin@e disc, press one of DISC DIRECT pLAY 1-5 to
start play.
To select disc 4 or 5 from the remote control, press DISC DIRECT
PLAY 4 or 5 while pressing SHIFT.
During random play it is not possible to skip to the previously
played itrack with 4.
Up to 30 tracks can be programmed from any of the inserted
discs.
Use the remote control.
1
2
3
Press PRGM while pressing SHIFT in stop mode.
"PRG" is displayed .
Press one of DISC DIRECT PLAY 1-5 to select a
disc.
To select disc 4 or 5, press DISC DIRECT PLAY 4 or
5
while
pressing SHIFT.
Go to the next step when the tray stops rotating.
Press numbered buttons O-9 and +1 Oto program
a track.
Example:
To select the 25th track, press +1O, +1O and 5.
To select the 10th track, press +1O and O.
Selected track number Total number of selected tracks
Program number
Total play~ng time of "the
selected tracks
4 Repeat steps 2 and 3 to program other tracks.
5 Press to start play.
To check the program
Each time + or - is pressed in stop mode, a disc number,
track number, and progra"m number will be displayed.
To clear the program
Press CLEAR in stop mode.
To add tracks to the program
Repeat steps 2 and 3 in stop mode. The track will be programmed
after the last track.
To change the programmed tracks
Clear the program and repeat all the steps again.
To play the programmed tracks repeatedly
After programming the tracks, press RANDOM/REPl:AT
repeatedly while pressing SHIFT until G appears on the display.
m
During programmed play, you can not use random play, check
the remaining time or select a disc or track.
ENGLISH 10