NexiGo 1548 Manual

Table of Contents

Contents

1 Product Introduction
2 What's in the Box
3 Installation Guide
4 Alternate Installation Instructions for Controller Holder
5 Contact Information
6 Documents / Resources
- 6.1 References
- 6.2 Download manual

NexiGo 1548 Manual

Product Introduction

The NexiGo 1548 Console Wall Mount with Controller Holders is designed exclusively for the P-5 console, and is compatible with both Digital and Disc editions. Simply attach the wall mount using the included screws and wall anchors for a secure, stable installation. It provides easy access to the console and controllers while keeping them secure, so you dont have to hide your new toys in your entertainment center or worry about breaking them!

What's in the Box

Installation Guide

Position the console wall mount at an appropriate location on the wall and then locate the screw holes in the wall mount. Use a level (NOT INCLUDED), to make sure that the mount is level on the wall. Mark each hole carefully with a pencil or pen to ensure that the item is mounted in the correct location. Once you have marked the holes, repeat this process with the controller holders. (See below for alternate mounting instructions for the controller holders.)
Drill a hole at each mark (Drill and drill bit NOT INCLUDED).
Insert a walI anchor into each hole and hammer in the wall anchors so they are nearly flush with the wall surface. (Hammer NOT INCLUDED)
Insert screws into the wall anchors, but do NOT fully insert the screws into the walI. Leave approximately 1/4 to 1/2 of an inch of the screw sticking out of the wall
Slide the console walI mount and controller holders onto the screws, and then slide the items down to ensure they are firmly attached.
Tighten the screws with the provided screwdriver to ensure that the console wall mount and controller holders are firm and secure. The controller holders and console wall mount are both ready to use!
Place the P 5 console on the console wall mount and affix the console to the mount using the provided P-5 connector screw.

Alternate Installation Instructions for Controller Holder

Clean the surface where you want to place the controller holder. (Sticker may remove paint. Use with care.)
Peel the backing from one side of the mounting tape and apply the mounting tape to the controller holder as shown in the image below.
Once the mounting tape is attached to the controller holder, remove the other side of the mounting tape backing. Locate the spot you want to attach the controller holder, and then carefully press the controller holder into place in that location. Press and hold firmly for 30 seconds to secure the controller holder where you are mounting it to.
After the controller holder is attached, please wait about an hour before using the item to make sure the controller holder is firmly attached. The glue will require some time to bond in place, using it before this has happened may cause the glue to fail and this could damage the controller, wall or mount. After waiting an hour, the controller holders will be ready to use.

Contact Information

Website: www.nexigo.com
Manufacturer: Nexight INC
Email: cs@nexigo.com
Tel: +1(458) 215-6088
Address: 11075 SW 11th St. Beaverton, OR 97005, US

If you have any problems, please contact us at cs@nexigo.com at any time for further assistance. This product is covered by our industry leading 1-year manufacturer's warranty. Register at nexigo.com/warranty or scan the QR code to get a FREE additional 1-year warranty!