Download Print this page

Senix X2 HTPX2-M-EU Instruction Manual page 11

Cordless pole hedge trimmer

Advertisement

Locking Clip
Locking Clip Nut
ADJUSTING THE PIVOTING
HEAD
WARNING!
Always ensure that it is locked into position
before using.
1. Turn off the machine and disconnect the
battery pack from the trimmer before
making adjustments.
2. Place the pole trimmer on a sturdy flat
surface.
3. The trimmer head can be adjusted to six
positions. Press the pivot button and adjust
the trimmer head to the desired angle.
4. Ensure the trimmer head is locked in
position when the button is released.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool
stops automatically. In this situation, let the
power tool/battery cool before turning the tool
on again.
SENIX.COM.AU
Hex Key Tool
Fig. 10
Fig. 11
OVERDISCHARGE
PROTECTION
When the battery capacity is not enough, the
tool stops automatically. In this case, remove
the battery from the tool and charge the
battery.
USING THE POLE HEDGE
TRIMMER
• Double check that the binding of
accessories and attachments are properly
fixed.Never use the product if any parts are
in the unlocked position.
• We recommend the use of the shoulder
strap at all times, to assist with distributing
the weight of the machine.
• Inspect the area to be cut and remove any
foreign objects that will influence your
cutting. If the foreign objects can not be
removed, e.g. wire fences, please mark and
remember it to avoid toughing them during
cutting.
• Run the machine to top speed before
cutting.
• Keep your body and feet in safety distance
to cutting head.
• Stand so that you are stable and balanced
on both feet. This hedge trimmer is
intended to be used by the operator at
ground level and do not use on ladders or
any other unstable support.
• The unit is used for cutting in either
direction in a slow, sweeping action from
side to side.
• Inspect and clear the area of any hidden
objects.
• To protect yourself from electrocution,
do not operate within 10m (33 feet) of
overhead electrical lines.
• Never use the pole hedge trimmer near
power lines, fencing, posts, buildings or
other immovable objects.
• Never use a blade after hitting a hard object
without first inspecting it for damage. Do
not use if any damage is found.
• Ensure the air vents are always
unobstructed and clear. Clean them if
necessary with a soft brush. Blocked
air vents may lead to overheating and
damaged to the trimmer.
• Do not overwork yourself. Take regular
breaks to ensure you can concentrate on
the work and have full control over the pole
trimmer.
11 - EN

Advertisement

loading
Need help?

Need help?

Do you have a question about the X2 HTPX2-M-EU and is the answer not in the manual?

Subscribe to Our Youtube Channel