MELICONI PJN21056 Manual

Personal 6+
/ PJN21056 / PJN240026
Remote control for TV sets TELEFUNKEN ready to use
Thank you for choosing a Meliconi remote control.
Before starting to use the product, read carefully and completely this manual and the
safety warnings
This remote control, after inserting the batteries, is normally ready for use as it is already set at the factory with a
specific code.
If problems are found to command the TV, or some functions do not produce the desired effect, to follow the
instructions to the chapter ACTIVATION OF REMOTE CONTROL.
TELEFUNKEN
The Personal 6+ remote control is designed to command a digital television sets.
Its ergonomic shape and soft rubber body make it easy to grip and protect it from shocks and drops.
By LEARN function, you can capture and store infrared signals from other remotes and match at will to one or more buttons.
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio frequency
(e.g. voice commands and pointers) are not supported.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
SAFETY WARNINGS
Before using the product, it is recommended to read the safety warnings
included in the package and available at the following link:
https://www.cme.it/meliconi/safety.pdf
INSERTING THE BATTERIES
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the package. Insert with the
correct polarity as shown in figure.
DO NOT use rechargeable batteries.
5
BATTERIES TEST: Press and hold the button and check that the LED remains on continuously until the button
is released. If the light is off or blinks, the inserted batteries are low, therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
ACTIVATION OF REMOTE CONTROL
Before using the remote control, for each device you wish to control, it is essential to set a specific code, it matched.
Identify the specific code and set it into the remote control using one of the following ways:
SMARTPHONE MANUAL
TABLET - WEB SEARCH
SMARTPHONE - TABLET - WEB
Use the qr-code on the side or connect to the www.cme.it page and follow the instructions.
Once you have found the specific code for your device, set it in the remote control as described in the ENTERING
THE CODE DIRECTLY chapter.