MELICONI TLC02+ Manual

TLC02+
/ PJN21059
Remote control for TV sets LG ready to use
Thank you for choosing a Meliconi remote control.
Before starting to use the product, read carefully and completely this manual and the
safety warnings
This remote control, after inserting the batteries, is normally ready for use as it is already set at the factory with a
specific code.
LG
The TLC02+ remote control is designed to command a digital television sets.
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio frequency
(e.g. voice commands and pointers) are not supported.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
SAFETY WARNINGS
Before using the product, it is recommended to read the safety warnings
included in the package and available at the following link:
https://www.cme.it/meliconi/safety.pdf
INSERTING THE BATTERIES
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the package. Insert with the
correct polarity as shown in figure.
DO NOT use rechargeable batteries.
5
BATTERIES TEST: Press and hold the button and check that the LED remains on continuously until the button
is released. If the light is off or blinks, the inserted batteries are low, therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
BUTTONS AND FUNCTIONS
The functions of the buttons on the MELICONI remote control are only available if the original device is equipped with it.
Sometimes some functions of the original remote control are not directly present on the MELICONI remote control keypad.
To enable them, connect to the www.cme.it page, use the on-line tool BUTTONS AND FUNCTIONS and continue until you see the list
matching buttons between the original remote control and the MELICONI remote control.
To obtain some functions, press and hold the button and press the corresponding key indicated in the table.
If the functions you want to play are matched with an number in orange color, operate as follows:
1. On the MELICONI remote control press and hold the button until the LED lights up; release.
2. Enter the code 0707.
3. While the LED remains on, enter the previously identified number corresponding to the function you want to play.
4. While the LED flashes, within 30 seconds, on the MELICONI remote control press the desired button to match the
function obtained.
5. Repeat the procedure from point 3 for each function you want to add on MELICONI remote control.
6. To end the procedure, hold down the button and wait for three flashes of the LED indicating that the storage has
been completed; release the button (the used buttons loses their original function that will be called by setting again the
activation code).