MELICONI Fully 8+ Manual

Fully 8+
/ PJN21050 / PJN231240
Thank you for choosing a Meliconi remote control.
Before starting to use the product, read carefully and completely this manual and the
safety warnings
The Fully 8+ remote control is designed to command up to 8 different devices of the following types: TV - SAT (satellite decoder) - TER
(digital terrestrial decoder) - DVD (Dvd and Blu Ray) - PVR (Personal Video Recorder and Media Center) - CAB (cable TV) - ADSL (ADSL
decoder) - AUX (other audio video equipments).
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio frequency
(e.g. voice commands and pointers) are not supported.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
SAFETY WARNINGS
Before using the product, it is recommended to read the safety warnings
included in the package and available at the following link:
https://www.cme.it/meliconi/safety.pdf
INSERTING THE BATTERIES
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the package. Insert with the
correct polarity as shown in figure.
DO NOT use rechargeable batteries.
5
BATTERIES TEST: Press and hold the button and check that the LED remains on continuously until the button
is released. If the light is off or blinks, the inserted batteries are low, therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
SELECTION OF OPERATING MODE
WARNING:
As the remote control is capable of controlling 8 devices, during setup (and also during normal use), you must select the
operation mode; then define which device you want to control. (TV / SAT / ecc.)
To select the operation mode for the first 4 devices, press for a moment one of the 4 device selection buttons at the top
corresponding to the device you wish to operate (example: TV ).
To operate with the 5 / 6 / 7 / 8 devices, keep the key pressed and then press the relative key.
ACTIVATION OF REMOTE CONTROL
Before using the remote control, for each device you wish to control, it is essential to set a specific code, it matched.
Identify the specific code and set it into the remote control using one of the following ways:
SMARTPHONE MANUAL
TABLET - WEB SEARCH
SMARTPHONE - TABLET - WEB
Use the qr-code on the side or connect to the www.cme.it page and follow the instructions.
Once you have found the specific code for your device, set it in the remote control as described in the ENTERING
THE CODE DIRECTLY chapter.