MELICONI EASY 900 Manual

Remote control for TV sets HISENSE ready to use
Before starting to use the product, read carefully and completely this manual and the
This remote control, after inserting the batteries, is normally ready for use as it is already set at the factory with a
If problems are found to command the TV, or some functions do not produce the desired effect, to follow the
The EASY 900 remote control is designed to command a
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio frequency
(e.g. voice commands and pointers) are not supported.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
Before using the product, it is recommended to read the safety warnings
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the package. Insert with the
correct polarity as shown in figure.
DO NOT use rechargeable batteries.
BATTERIES TEST: Press and hold the
the button is released. If the light is off or blinks, the inserted batteries are low, therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
If problems are found to command the TV, or some functions do not produce the desired effect, please proceed as follow:
• Press and hold for at least 8 seconds the 2 numeric button.
• Three final flashes indicate that the operation has been completed successfully.
• Now check if the remote control act properly.
If not, again repeat the procedure using from 3 to 0 numeric buttons, until proper operation.
To restore the remote control and return to the initial condition, perform the procedure using the 1 button.
To consult the key correspondence table between the Meliconi remote control and the functions of the original remote control, go to
www.cme.it , select the remote control model and click on "KEY CORRESPONDENCE TABLE".
EASY 900
Thank you for choosing a Meliconi remote control.
instructions to the chapter ACTIVATION OF REMOTE CONTROL.
SAFETY WARNINGS
included in the package and available at the following link:
https://www.cme.it/meliconi/safety.pdf
INSERTING THE BATTERIES
GUIDE
button and check that the LED remains on continuously until
ACTIVATION OF REMOTE CONTROL
/ PJN23033
safety warnings
specific code.
HISENSE
digital television sets.