MELICONI TLC Solar TV Manual

TLC Solar TV
/ PJN231255
Thank you for choosing a Meliconi remote control.
Before starting to use the product, read carefully and completely this manual and the
safety warnings
The TLC SOLAR TV is an innovative remote control that can operate and control a TV set without batteries.
It is equipped with an energy accumulator that can be charged with a USB type C cable and a solar cell which, using light (indoor use
only), maintains the minimum charging threshold, without any waste of energy, in order to allow the daily use of the remote control.
Unlike rechargable batteries, the accumulator does not deteriorate over time, even after thousands charging cycles, it does not require
replacement, thus covering the entire life cycle of the remote control.
By LEARN function, you can capture and store infrared signals from other remotes and match at will to one or more buttons.
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio frequency
(e.g. voice commands and pointers) are not supported.
This remote control has a permanent memory, it does not lose settings even if it is completely discharged.
SAFETY WARNINGS
Before using the product, it is recommended to read the safety warnings
included in the package and available at the following link:
https://www.cme.it/meliconi/safetysolar.pdf
REMOTE CONTROL RECHARGE
Before using the remote control, provide a fully recharge (approx. 10min):
- Make sure the switch on the back of the remote control is in the "ON" position.
- Insert the type C connector of the supplied cable into the remote control charging socket
- Plug the other end of the USB cable into a port of an USB certified charger.
- When the remote control is charging, the LED flashes.
- When the recharging is complete, the LED remains fixed.
In case of prolonged non-use, switch off the remote control using the ON/OFF switch on the back of the remote.
It is recommended, if possible, to place the product near a light source in order to maintain a minimum level of charge.
The solar cell can recharge even when the switch is in OFF position.
5
BATTERIES TEST: Press and hold the button and check that the LED remains on continuously until the button is released. If the
light is off or blinks, the remote control is not sufficiently charged and need to be recharged.
ACTIVATION OF REMOTE CONTROL
Make sure the switch on the back of the remote control is in the "ON" position.
Before using the remote control, for each device you wish to control, it is essential to set a specific code, it matched.
Identify the specific code and set it into the remote control using one of the following ways:
SMARTPHONE MANUAL
TABLET - WEB SEARCH
SMARTPHONE - TABLET - WEB
Use the qr-code on the side or connect to the www.cme.it page and follow the instructions.
Once you have found the specific code for your device, set it in the remote control as described in the ENTERING
THE CODE DIRECTLY chapter.