MELICONI PJN22003 Manual

Control 2+
/ PJN22003 / PJN231216 / PJN231239
Thank you for choosing a Meliconi remote control.
Before starting to use the product, read carefully and completely this manual and the
safety warnings
The Control 2+ remote control is designed to command a TV and a DECODER (satellite or digital terrestrial).
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio frequency
(e.g. voice commands and pointers) are not supported.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
SAFETY WARNINGS
Before using the product, it is recommended to read the safety warnings
included in the package and available at the following link:
https://www.cme.it/meliconi/safety.pdf
INSERTING THE BATTERIES
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the package. Insert with the
correct polarity as shown in figure.
DO NOT use rechargeable batteries.
5
BATTERIES TEST: Press and hold the button and check that the LED remains on continuously until the button
is released. If the light is off or blinks, the inserted batteries are low, therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
SELECTION OF OPERATING MODE
WARNING:
As the remote control is capable of controlling 2 devices, during setup (and also during normal use), you must
select the operation mode; then define which device you want to control. (TV / STB)
To select the operation mode, press the button quickly and repeatedly until the LED corresponding to the
device you want to operate is switched on. (TV = red led / STB = green led)
ACTIVATION OF REMOTE CONTROL
Before using the remote control, for each device you wish to control, it is essential to set a specific code, it matched.
Identify the specific code and set it into the remote control using one of the following ways:
SMARTPHONE MANUAL
TABLET - WEB SEARCH
SMARTPHONE - TABLET - WEB
Use the qr-code on the side or connect to the www.cme.it page and follow the instructions.
Once you have found the specific code for your device, set it in the remote control as described in the ENTERING
THE CODE DIRECTLY chapter.