Adexa HEP-12 Instruction Manual page 8

Instruction Manual
• Never touch the power cord, plug, or switch with wet hands to prevent electrical
hazards.
• Do not leave the appliance unattended during operation to avoid accidents.
• WARNING: Electrical Hazard! Ensure the voltage of the local power supply matches the
rating on the appliance's nameplate. Failure to do so can cause damage or safety risks.
Always prioritize safety and follow these guidelines for proper operation and maintenance
of the appliance.
5.2 Installation and Connection
ATTENTION!
• The installation of this appliance must be carried out by a qualified technician to ensure
proper setup and safe operation.
• Place the device on a solid, even, and stable surface capable of supporting its weight.
Ensure the unit is leveled both front-to-back and side-to-side for optimal performance.
• Never place the appliance on flammable surfaces, such as tablecloths, carpets, or any
combustible materials.
• Avoid positioning the unit near open fireplaces, electric ovens, heaters, or any other
heat sources to prevent overheating and potential fire hazards.
• Ensure the appliance is positioned so that the plug remains easily accessible at all
times.
• Take care to prevent liquids from entering the electrical system or switch. If any liquid
comes into contact with the appliance, thoroughly dry it off before use to avoid electrical
hazards.
Adhering to these instructions will ensure a safe and efficient installation of your appliance.
5.3 Operating Instructions
ATTENTION!
• The operation of the device may only be performed by personnel who have been trained
in its use.
• Connect the plug to a properly grounded socket.
Controls Overview:
• This series of electric conveyor pizza ovens is equipped with two temperature control
knobs:
The upper temperature control knob adjusts the heating elements on the top.
-
- The lower temperature control knob adjusts the heating elements on the bottom.
• The mains rocker switch in the center of the control panel powers the device.
• The right black switch allows adjustment of the direction of the conveyor motor.
• The conveyor belt speed can be adjusted using the bottom rotary switch on the right
side.
Preparing for Operation:
• Conveyor and Chain Tension:
Adjust the tightness of the conveyor by repositioning the fastening screw in the
-
upper hole of the fastening box for the chain net.
8