SMC Networks EXW1-RAXZA2C Operation Manual page 31

• Wireless adapter phenomenon
LED
- All LEDs are OFF.
PWR PWR LED is red or flashes orange or is off.
W-SS W-SS LED flashes red or orange or is off.
• Wireless Adaptor troubleshooting
Problem LED
Color of
No. name
LED
1 All
Orange
2 PWR
3 W-SS
Orange
Description
LED status
ON/Flashing
- OFF Power supply is OFF
- OFF Power supply is OFF
Internal communication error
Flashing
with the wireless adaptor.
Red ON Wireless Adaptor malfunction.
When Protocol V.1.0 is used.
(1) Power supply of registered
Red Flashing Base is OFF.
(2) Outside the wireless
coverage area.
When Protocol V.2.0 is used.
(1) Power supply of registered
Flashing Base is OFF.
(2) Outside the wireless
coverage area.
(1) Factory condition
- OFF
(2) Power supply is OFF
LED status
Color of LED
-
Orange
Red
Red
Orange
-
Possible causes
Supply 24 VDC +/-10% for power source.
Supply 24 VDC +/-10% for power source.
Check for loose connectors and broken wires.
Replace the Wireless Adaptor. If the error
persists after replacement, stop using the
equipment and contact your SMC sales
representative.
(1) Supply 24 VDC +/-10% to the US1 (for
control / input) power source of the
registered Base.
(2) The distance which wireless
communication between wireless systems can
be established may have been exceeded.
Reconsider the operating environment, such
as the installation conditions, of the Base
and Remote.
(1) Supply 24 VDC +/-10% for power source
of the Base.
(2) The distance which wireless
communication between wireless systems can
be established may have been exceeded.
Reconsider the operating environment, such
as the installation conditions, of the Base
and Remote.
(1) Factory condition. Perform pairing.
(2) Supply 24 VDC +/-10% for power source.
-30-
ON/Flashing
- Problem 1
OFF
Flashing Problem 2
ON
Flashing
Flashing Problem 3
OFF
Investigation and countermeasures
Doc.DOC1104200-1
№