Advertisement
Quick Links
HIGH LIFT JACK MOUNT
FOR 2018+ JEEP WRANGLER JL
Please visit www.aev-conversions.com to view the most current
This is a new product and we want to make sure that you receive the latest
and most accurate information based on customer feedback, product
revisions, and/or model year updates. We value customer feedback, so we
encourage you to contact our Technical Support department if you have
any suggestions on how to make the installation of this product easier or if
you have any questions regarding the installation of this product. AEV's
Technical Support can be reached by email at tech@aev-conversions.com
or by giving us a call at (248)-926-0256.
AEV30349AA
Last Updated: 06/04/2024
NEW PRODUCT
installation guide for this product.
Written By: Zachary Buhro
Approved By:
Advertisement
Related Manuals for AEV 52060004AA
Summary of Contents for AEV 52060004AA
- Page 1 Technical Support department if you have any suggestions on how to make the installation of this product easier or if you have any questions regarding the installation of this product. AEV’s Technical Support can be reached by email at tech@aev-conversions.com or by giving us a call at (248)-926-0256.
- Page 2 These instructions assume a certain amount of mechanical ability and are not written nor intended for someone not familiar with auto repair. INCLUDED PARTS REQUIRED TOOLS Accessory Mount Weldment Common Hand Tools (AJLB0300AA) Foot Plate Weldment (AJKZ0107AA) Accessory Mount Clamp (AJLB3000AA) Accessory Mount Hardware Pack ©2024 AEV...
- Page 3 ©2024 AEV...
- Page 4 Accessory Mount Clamp Accessory Mount Weldment Wrench. 3/8" Washer and 3/8" - 16 Nylon Lock Nut as shown DO NOT OVERTIGHTEN—Bracket should swing easily. Figure 1 (left) and 2 (right) Slide U-nut onto Accessory Mount Weldment Figure 3 ©2024 AEV...
- Page 5 flush against the tire carrier tube (figs 6 and 7). Note: Begin fastening at the bottom to allow for proper alignment. Figures 4 (top left), 5 (top right), 6 (bottom left), and 7 (bottom right) ©2024 AEV...
- Page 6 Remove cotter pin from the Hi-Lift footplate. Remove factory Hi-Lift footplate and replace with AEV Hi-Lift footplate (fig 9). Replace cotter pin. Figures 8 (left) and 9 (right) ©2024 AEV...
- Page 7 Hi-Lift Jack and fasten the Hi-Lift locking stud knob (fig 12) Accessory Mount Clamp sliding it through hole on jack column and tightening it securely into U-nut. Note: The Hi-Lift Jack must be in its lowest position to prevent damage to the tail light when opening the tailgate. ©2024 AEV...
Need help?
Do you have a question about the 52060004AA and is the answer not in the manual?
Questions and answers