DIGITRAK FALCON F1
USER MANUAL
DCI DigiGuide
05.18.2024
Calibration is required anytime you change your transmitter, locator, drill
head, or perform a new frequency scan and then pair.
Calibrate with the transmitter in the housing flat on the ground in a low-noise,
metal-free environment immediately after pairing.
To calibrate any other time,
from the Main menu select
Calibration, then 1PT CAL
before continuing with the
following steps.
STEP 2 OF 8
Install the powered-on transmitter in the drill head and install the cover.
STEP 3 OF 8
Using a tape measure, place the near edge of the locator parallel to and
exactly 10 ft (3 m) from the center of the drill head.
25
DIGITAL CONTROL, INC
Need help?
Do you have a question about the DIGITRAK FALCON F1 and is the answer not in the manual?